THB Pressure Switch ( For Air Compressor ) Miter Saw Ridgid Bending & Hole Cutting

Ridgid Bending & Hole Cutting

Duty Cycle: 80%

160 Nm No-load speed 0 rpm Tool holder 1/4'' Hex Uni No-load speed (1st level) 0-2

000 Thread M 10 For angle grinders

this rugged mitt gives you the strength and control needed to tackle hair

THB Pressure Switch ( For Air Compressor ) Miter Saw Ridgid Bending & Hole CuttingHIGHLIGHTS: The air compressor pressure switch helps to measure the pressure inside your air tank and then is used to shut off your compressor when your air tank reaches the desired air pressure. The air compressor pressure switch will also help your machinery maintain the proper pressure level as you go about your work. SPECIFICATIONS: E22 SINGLE PORT Min ON (Cut In) PSI 40 Max Off (Cut In) PSI 180 Differential PSI 30 ~ 40 Factory Setting PSI 85 115