CRL Panther Edger 3/16" Flat with Arris Diamond Wheel Backer Rods & Insert Tools allowing easy direction change and

allowing easy direction change and uninterrupted flow

LD903SW replacement Switch

Makes Cuts Up to 72" (1829 mm) Wide

Holds Standard Caulking Cartridges

New Seal Puncture Device Built into Handle

CRL Panther Edger 3/16" Flat with Arris Diamond Wheel Backer Rods & Insert Tools allowing easy direction change andUsed Exclusively for CRL's Panther Edger The CRL Diamond Wheel 1 8" Flat with Arris is used primarily for grinding 1 8" (3 mm) glass, this diamond wheel represents the same quality product that is supplied with the CRL Panther Edger. A clean satin edge is produced with this wheel. A full 4" (102 mm) in diameter, under optimum conditions, it should last 400,000 linear inches. Product images shown are of the actual product or a close representation.